SPOT Device with SafetyLine

Device must be powered on.

OK button - Begin Monitoring with SafetyLine and reset your check-in interval.

Custom Message button - End Monitoring with SafetyLine.

Help button - Alert a SafetyLine Monitor during an Emergency.

Note: The S.O.S. button alerts GEOS emergency responders and NOT your SafetyLine Monitors.
It should only be used for critical, life-threatening situations.

 ************************************************************************************

The following detailed instructions are from SPOT's Gen3 User Guide: Download Here

POWER

TO TURN SPOT ON: Simply locate the Power button on the upper left corner of the device, press and hold the button; lights will illuminate.
TO TURN SPOT OFF: Press and hold the Power button until the Power light blinks rapidly

USING THE CHECK IN OR CUSTOM MESSAGE FUNCTION

Press and hold the Check In or Custom Message button until the function light blinks green.
The GPS light will blink green when SPOT sees the GPS satellites and will continue blinking while obtaining your GPS location.

USING THE HELP FUNCTION

To send a Help message, open the protective flap then press and hold the Help button until the light blinks green.
The GPS light will blink green when SPOT sees the GPS satellites and while obtaining your GPS location.

TO CANCEL

You can end the transmission of a Check In or Custom Message by pressing and holding the function button until the light blinks red.
This action does not cancel any message already transmitted.

MESSAGE INDICATORS

For all functions, SPOT lets you know what it is doing

INDICATOR	BLINKING GREEN	BLINKING RED
GPS	Searching for GPS signal	GPS location fix failed, move to a new location
Message Sending	Message transmission  schedule in progress	Last message was not sent
Check In or Custom Message	Message sequence in progress	Message sequence has been cancelled
Help	SPOT in Help/ SPOT Assist mode	Help/SPOT Assist has been cancelled
Power	On	Low Battery